Fw 8.7

[tinyhunter]

Kurze Frage, hat irgendwer schon Erfahurungen mit der 8.7 FW, da sie ja doch schon etwas laenger draussen ist?

 

[jogyfl]

Ich habe ein 7940 und nutze auf dem die FW 8.7, bis jetzt läuft alles ohne Probleme.

 

[chaos2000]

Was sind die "Unterschiede" in der 8.7 zur 8.2?

 

[janthedoc81]

Hallo,

die Firmware läuft einwandfrei.

Die Unterschiede kann ich Dir auch nicht erklären, aber hier die Fehlerbehebungen von Cisco:


Cisco Unified IP Phone (SIP) running firmware version 8.3 crashes and traps intermittently

Shutdown Survivable Remote Site Telephony (SRST) service but Cisco Unified IP Phone (SIP) still shows SRST active (Pub, Sub down)

Cisco Unified IP Phone crashes during active call while accessing network settings

Multiple INVITE messages sent out when primary proxy is down

Cisco Unified IP Phone 7960/7940 (SIP) crashes when ‘cprGetBuffer()’ fails

Call to Cisco Unified IP Phone 7960 (SIP) second line fails when a conference exists on the first line

Cisco Unified IP Phone (SIP) experiences one-way audio issues under certain condition

Cisco Unified IP Phone (SIP) does not use good server when outbound proxy configured

Cisco Unified IP Phone 7960/7940 (SIP) does not advertise comfort noise in Session Definition
Protocol (SDP) when Voice Activity Detection (VAD ) is on

Cisco Unified IP Phone 7960/7940 (SIP) does not register with back up proxy
User Agent Server (UAS) sends ‘500’ response to the mismatch request

Cisco Unified IP Phone (SIP) does not failover for multiple responses for proxy address

Cisco Unified IP Phone (SIP) rejects INVITE message if header value is invalid
Cisco Unified IP Phone 7960 (SIP) hangs and the call rings out when the call ends

Cisco Unified IP Phone 7960 hangs when dialed from directory while in a conference

CANCEL/ACK message is missing ‘to’ tag during race condition

Cisco Unified IP Phone (SIP) gets stuck in partially registered state

Inconsistent ‘sh ip RxFrags’ and ‘RxFragDrops’ messages

Cisco Unified IP Phone 7960/7940 (SIP) sends ‘486 busy’ for incoming call when of

Cisco Unified IP Phone 7960 (SIP) sends bad ‘to’ tag in INVITE message, in redirect

Cisco Unified IP Phone 7960 (SIP ) crashes when receiving calls in SRST mode

RTP information is not available in SIP messages after upgrade on Cisco Unifie
Transfer or conference to URL in directory does not work


Gruss


Jan

 

[tinyhunter]

Danke fuer die Infos. Habe sie drauf und läuft soweit auch so gut.