# poll=<number>
#
# Only one poll value must be given for all cards.
# Give the number of samples for each fifo process.
# By default 128 is used. Decrease to reduce delay, increase to
# reduce cpu load. If unsure, don't mess with it!!!
# Valid is 32, 64, 128, 256.
#
# dsp_poll=<number>
# This is the poll option which is used by mISDN_dsp, this might
# differ from the one given by poll= for the hfc based cards, since
# they can only use multiples of 32, the dsp_poll is dependant on
# the kernel timer setting which can be found in the CPU section
# in the kernel config. Defaults are there either 100Hz, 250Hz
# or 1000Hz. If your setting is either 1000 or 250 it is compatible
# with the poll option for the hfc chips, if you have 100 it is
# different and you need here a multiple of 80.
# The default is to have no dsp_poll option, then the dsp itself
# finds out which option is the best to use by itself
