BitSwitcher - neue Firmware für Speedport W500V

# pvc2684ctl -l

VC          interface  mode
--          ---------  ------
 1/  32     nas100032  Bridging

nas -i wl0 -S -m 4 -g 3600 -s [i]SSID[/i] -w 2 -k [i]ascii-key[/i]

wlctl wpa auth 4
wlctl wepstatus off
wlctl wsec 6
wlctl wet 1
wlctl join [i]SSID[/i] key [i]ascii-key[/i] amode wpapsk

#!/bin/sh

#### custom_start.sh script for BitSwitcher
#### with Wireless LAN client mode for a WPA protected network.

# settings
SSID="meinaccesspoint"
WPA_PSK="strenggeheim"
CHANNEL="1"

## Activate and configure wl0
wlctl up
wlctl ap 0
wlctl channel $CHANNEL
wlctl wet 1
wlctl wsec 6
wlctl wpa_auth 4
wlctl wepstatus 0

## Configure network bridge
brctl addif br0 wl0
# set forwarding delay down to 5 seconds, this should be ok at home.
brctl setfd br0 5
ifconfig wl0 up
ifconfig eth0 up

ebtables -t broute -A BROUTING -p arp -j ACCEPT
ebtables -t broute -A BROUTING -p ipv4 -j ACCEPT
ebtables -t broute -A BROUTING -p ipv6 -j ACCEPT
ebtables -t broute -A BROUTING -j DROP


# let the Online LDE flash to indicate connection attempt
ledtool 3 4

# run supplicant, to preconfigure wl0 (won't work with these settings)
nas -i wl0 -S -m 4 -k $WPA_PSK -s $SSID -w 6 -g 3600 &
sleep 5

# it has done it's job, just terminate or kill it
if (pidof nas); then 
    kill -TERM `pidof nas`
    sleep 1
    if (pidof nas); then 
	kill -KILL `pidof nas`
    fi
fi

# run supplicant with final settings
nas -i wl0 -S -m 4 -g 3600 -s $SSID -w 2 -k $WPA_PSK &
sleep 2

# join wireless network
wlctl join $SSID key $WPA_PSK amode wpapsk

if (wlctl status | grep 'Mode: Managed'); then
    # associated with AP, light up LED.
    ledtool 3 1
else
    # association failed, let it flash fast
    ledtool 3 5
fi